Chapter 3 Quiz

1. A network consulting company is preparing a network equipments document for a new client. The network design team is in the process of detailing the both physical and logical infrastructure, as well as the equipment and applications in use on the network. Which part of the network design equipments document is the design team preparing?
1. Overall goal
2. Project scope
3. Current state of the network
4. Network equipments

2. A new technician has been hired in the company IT department. The IT manager gives the new technician the most current logical and physical network diagrams to review. Which two pieces of information should the technician be able to learn from the diagrams? (Choose two.)
1. credentials for configuring devices
2. contact information?s for installation technicians
3. location of networking equipment
4. cost analysis of networking equipment
5. standard naming conventions
6. status of routing device links

3. A network technician is assignd the task of updating the existing documentation for a single branch network that consists of all Cisco devices. The technician runs the Cisco Network Assistant at the workstation and issues the commands show cdp neighors detail and show ip route on each device. Which two pieces of information can be determined by using these tools? (choose two.)
1. device types and software versions of connected equipment
2. workstation IP addresses
3. network hierarchy
4. total number of devices and hosts on the network
5. strengths and weaknesses of the current network

4. During the initial redesign of a company network, the IT administrator has requested that the accounting department LAN be exempt from the new network desin changes. In which area of the netwrk design is this exemption defined?
1. Overall project goal
2. Request for information
3. Current state of the network
4. Request for proposal
5. Network requirements
6. project scope

5. Refer to the exhibit. What piece of information can be obtained from the output of the show cdp neighbors detail command?
Advertisement version: 2
Duplex: full
-----------------------------------
Device ID: RICHMOND
Entry address(es):
IP address: 192.168.4.2
Platform: cisco PT1000-I-M, Capabilities: Router
Interface: Serial3/0, Port ID (outgoing port): Seriall/0
Holdtime: 150

Version:
Cisco internetwork Operating System Software
IOS ? PT1000 Software (PT1000-I-M), Version 12.2(28), RELEASE SOFTWARE
Technical Support: http://www.cisco.com/techsupport
Copright ? 1986-2005 by cisco Systems, Inc.
Complied Wed 27-Apr-04 19:01 by miwang
Advertisemnt version: 2
Duplex: full
------------------------------------

1. this device is a 2600 series router.
2. The neighboring device is a switch.
3. The neightboring device is using interface serial 1/0 to connect to this device.
4. The hostname of this device is RICHMOND